and bypass valve

When rebuilding a Triumph motor or top end you need to use the appropriate size gaskets to get the appropriate "squish" so you do not develop leaks at the pushrod tubes (This is covered in the Glenns Triumph Manual)

the gasket surface doesn't fully seat against the FiltroMax due to the way the steel center is formed on these filters

This frame comes with a pre-installed Oil Tank

transforming a once-complicated job into a quick process you can do in your own garage

Choppers Magazine Issue 23 Subcategory_Motorcycle Mirrors and bypass valveChoppers Magazine Issue 23 is here, and we aint playin with this one. We once again packed the pages with some of the best shows and builds from across the country, starting with the Kernville Kampout and the Biltwell 100, courtesy of our pals from Biltwell. Then we go a little further North for coverage of the Hopped Up Chopper Show. Then we head East for the Haints Hawg Wild Run you should buy the mag for this one alone. And how rad is it to see