the light is simply secured with 4 screws and connected directly to the receiver

Loosen the two screws above the spoiler and then the four screws on the sides of the spoiler bracket

Installation instructions

with cable ties or tape

to protect them and prevent them from coming into contact with sharp edges

Triple Spike DBXL 2.0 / DBXL-E 2.0 the light is simply securedExtremely bright rear LED, which is easily attached to the rear spoiler bracket. To install, simply clamp the light and connect it to the existing front LED connector. The installation is very straightforward and can be done without much effort. Installation Instructions Loosen the four screws on the spoiler bracket. Clamp the LED between the struts of the spoiler bracket and lightly tighten the screws again. Ensure that the LED is securely in place