3DE MAX PLA har en øget slagstyrke på op til 9 gange i forhold til den almindelige PLA og er 20% ​​mere hård end ABS

PETG and so on to the more abrasive ones

Due to a low shrinkage factor

The ATmega2560 provides four hardware UARTs for TTL (5V) serial communication

It adheres well to most build plates

FLUX - Charcoal Filter Replacement - Beam Air Creality 3D - Ender-3 MAX - Reservedel 3DE MAX PLA har enCharcoal Filter for your Beam Air It is recommended that the charcoal filter be replaced every 300 600 hours. Remember to also replace the other filters on time: See 3D Expert's selection of laser accessories here * Pre Filter (10 30 hours) * Medium efficiency filter (50 150 hours) * H13 HEPA filter (100 200 hours) * Charcoal filter (300 600 hours) Remove the filters: Open the top cover of the filter and remove the box from inside. Then take out the